Mercedes C-Class

W203 since 2000 of release

Repair and operation of the car



Mercedes-Benz
+ Mercedes-Benz cars of class C (W-203)
+ Operation manual
+ Routine maintenance
- Engine
   Check of a compression in engine cylinders
   Check of the engine by means of the vacuum gage
   Removal and installation of a cover of a motive compartment from the bottom
   + 4-cylinder petrol engines
   + 6-cylinder petrol engines
   - Diesel engines
      Removal and installation of the top cover of the engine
      Installation of the piston of the first cylinder in the provision of VMT
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a head of cylinders
      Removal and installation of a forward cover
      Removal and installation of the top guide of a chain
      Replacement of chains of the GRM drive and installation of phases of gas distribution
      Removal and installation of camshafts
      Removal and installation of an intermediate asterisk
      Removal and installation of a natyazhitel of a chain
      Removal and installation of a maple belt
   + Engine lubrication system
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment












Installation of the piston of the first cylinder in the provision of VMT

Removal

 PERFORMANCE ORDER

1. Uncover a head of cylinders, address the Section Removal and installation of a cover of a head of cylinders.

2. Install the piston of the first cylinder in the provision of VMT. For this purpose switch the transmission to the provision of the neutral course and turn a bent shaft a face key for the central bolt of fastening of a pulley of a bent shaft in the direction of rotation of the engine, i.e. clockwise. Rotate a bent shaft, so far a tag "FROM" on a pulley and the index will not coincide.

Do not rotate the engine crankshaft in the opposite direction. Do not rotate the engine crankshaft for a bolt of fastening of an asterisk of the camshaft.

3. In this situation the drift (1) (a lock pin) has to be entered through the first cover of bearings of the camshaft into an opening in an asterisk (2) camshafts of inlet valves. Otherwise turn a bent shaft on a whole revolution and again insert a drift.


Installation

 PERFORMANCE ORDER

1. Take out a lock pin.
2. Establish a cover of a head of cylinders, address appropriate section.