Mercedes C-Class

W203 since 2000 of release

Repair and operation of the car



Mercedes-Benz
+ Mercedes-Benz cars of class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
- Engine electric equipment
   + System of ignition and engine management
   + System of preheat of the diesel engine
   + Diagnostics of systems of electronic control and diagnostic equipment
   - Systems of a charge and start
      The rechargeable battery - the main data and acquisition of the new battery
      Check and charging of the rechargeable battery
      Replacement of the rechargeable battery
      Storage of the rechargeable battery
      System of charging - general information and security measures
      Check of system of charging
      Removal and installation of the generator
      Removal and installation of the regulator of tension. Replacement of brushes
      System of start of the engine - the general information and precautionary measures
      Removal and installation of a starter
      Removal and installation of the traction relay of a starter
      Check of system of start of the engine
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment







Removal and installation of the regulator of tension. Replacement of brushes

Petrol engines 111, 112

Removal

 PERFORMANCE ORDER

1. Remove the generator, address appropriate section.
2. Turn off nuts on plugs.

3. Turn out screws (1) and remove a protective cover (2) from the generator, having parted at the same time lock levels (3).

Depending on model of the engine generators of various power can be installed.

4. Turn out screws (4) and take out the regulator (5) aside. (6) – accession of weight.
5. Replace brushes for what unsolder cables.
6. Check wear of contact rings, if necessary, pierce them and polish (work HUNDRED).


Installation

 PERFORMANCE ORDER

1. Insert new brushes (A) and springs (V) into the brush holder (C) and solder them. The illustration has informative character and cannot correspond to completely considered model.

2. To exclude hit of solder at the soldering of new brushes, hold cables flat-nose pliers.

 Solder leads to curing of ropes that does them not efficient.

3. Establish and fix tension regulator.
4. After installation of new brushes check ease of their course in brush holders.
5. Fix the protection cover on the generator.
6. Fix nuts on plugs.
7. Install the generator, address appropriate section.